I noticed the bushing needed replaced,,How do i remove the trans pump,,,

 

I got it,,,Rented a slide hammer from autozone...
What is the retaining pin for ,,It came out when i pulled the pump off..I see where it goes,,,Do i just push it back in or does something need to be lined up?. i can slide it right back in..If it goes right back in is it in there right...I mean can it go in wrong...

 

What trans are you working on?

 

400

 

The only retaining pin I can recall in a 400 pump is for the pressure regulator. Get a manual and study it.

 

Be cautious when you service an automatic transmission. They have ZERO tolerance to dirt. Your workspace has to be very clean.

 

I figured it out in the manual...thanks every one,,,I have the pump seal,,,rear seal replaced..My work are was pretty clean i think,,,i was cautious not to let any dirt in...After i got each seal pulled and replaced I wrapped plastic around them so no dirt gets inside..I also relaced the filter and pan gasket,,