67 cutlass with 2 speed auto
#1
67 cutlass with 2 speed auto
Why is it so expensive to put a manual trans in? Id love a 4 speed manual. Could just leave the column shifter where it is, cut a hole in the floor for the stick and everything. But why does it all cost so much? Ive hearf people say itll cost me lile 7500 including labor.
#2
I think the biggest cost is to do it right you need to have the crank drilled for a Manuel witch at that point you need to rebalance and might as wells kick in then your looking at a engine over haul. i would think you could round up most parts for around 3000.00 but I am not positive
#3
Why is it so hard to install a 4 speed?
Because its so damn easy to put in an automatic instead!
I have passed up 4 speed cars before because I have had enough of them to know I have nothing to prove to the world with pushing the clutch in and out 500 times on Main Street during a cruise!
Because its so damn easy to put in an automatic instead!
I have passed up 4 speed cars before because I have had enough of them to know I have nothing to prove to the world with pushing the clutch in and out 500 times on Main Street during a cruise!
#4
Why is it so hard to install a 4 speed?
Because its so damn easy to put in an automatic instead!
I have passed up 4 speed cars before because I have had enough of them to know I have nothing to prove to the world with pushing the clutch in and out 500 times on Main Street during a cruise!
Because its so damn easy to put in an automatic instead!
I have passed up 4 speed cars before because I have had enough of them to know I have nothing to prove to the world with pushing the clutch in and out 500 times on Main Street during a cruise!
#5
Why is it so expensive to put a manual trans in? Id love a 4 speed manual. Could just leave the column shifter where it is, cut a hole in the floor for the stick and everything. But why does it all cost so much? Ive hearf people say itll cost me lile 7500 including labor.
Maybe that price includes the MIGHTASWELL engine rebuild as part of pulling the crank to drill it.
Thread
Thread Starter
Forum
Replies
Last Post
ignachuck
General Discussion
0
June 12th, 2015 05:29 PM
1965F85_scholten
Cutlass
10
September 22nd, 2013 07:00 AM
garys 68
Brakes/Hydraulic Systems
0
December 21st, 2010 03:32 PM