200-4R Bellhousing Pattern Recognition
#1
200-4R Bellhousing Pattern Recognition
I read in an Aceshigh thread that this trans comes in three bellhousing bolt patterns: BOP, Dual BOP/Chevy, and Chevy - is this correct? I guess that means that the Chevy pattern will only fit a SBC? I'm asking because I found a 5CQ (Monte SS), which I think has the dual bellhousing, but I'm not sure. Looking at the pic, it looks like it has the two sets of holes, but it's also got the Chevy "peak." From the drawings on the above mentioned thread, it looks like the Dual pattern has a flat top, not the Chevy peak. I apologize if this has been covered in another thead, I searched but could'nt find an answer. Thanks for any help - mark
https://classicoldsmobile.com/forums...i-learned.html
https://classicoldsmobile.com/forums...i-learned.html
Thread
Thread Starter
Forum
Replies
Last Post
RAMBOW
Transmission
6
December 9th, 2009 12:26 PM