Tri Carb Intake and carbs
#1
Tri Carb Intake and carbs
$4999 For the intake , carburetors , mounting studs , Cross Over Block Offs , air cleaners , linkages and fuel lines
Pick UP OSSEO MN
Intake is cast with AU
Pick UP OSSEO MN
Intake is cast with AU
Last edited by 11971four4two; June 2nd, 2023 at 12:21 PM.
#4
HI
I did lower the price to $4999 on JUNE 2nd
If you want to spend less $$ I will sell The Carbs , Linkage , air filters and fuel lines with a BARE INTAKE Manifold it is casting AZ FOR $4500 CASH
Pictures of AZ manifold....
I did lower the price to $4999 on JUNE 2nd
If you want to spend less $$ I will sell The Carbs , Linkage , air filters and fuel lines with a BARE INTAKE Manifold it is casting AZ FOR $4500 CASH
Pictures of AZ manifold....
#7
HI
I was out of town most of the week.. Home late last night
You are correct NO I will not sell the AU (painted intake with block offs) and carbs etc for $4000 Thank you for the offer
I would sell the AZ BARE not painted and NO Block offs , with the carbs etc for $4000 CASH
The AU Painted intake with block offs NO CARBS etc.. $3200 or $4999 with carbs
This is picked up near minneapolis
Buyer will have to pay their own travel expenses
I was out of town most of the week.. Home late last night
You are correct NO I will not sell the AU (painted intake with block offs) and carbs etc for $4000 Thank you for the offer
I would sell the AZ BARE not painted and NO Block offs , with the carbs etc for $4000 CASH
The AU Painted intake with block offs NO CARBS etc.. $3200 or $4999 with carbs
This is picked up near minneapolis
Buyer will have to pay their own travel expenses
#10
The AL/AU tri carb intakes have a uneven flange for the center carb on the front of the mounting pad. They fixed this on the AZ version with a straight mounting flange. The AL/AU intakes have about .070 of pinch/sealing area and can lead to leaking. The factory fix for this was to use a sealer on the center carb gasket. There is absolutely nothing wrong with the AL/AU intakes,they work as well as the AZ. The AL intake has a coil mounting boss in the very rear of it and makes it harder to mount. The AU/AZ have the coil mounting boss up top next to the rear carb and makes for easier mounting. There is no performance advantage between the 3 versions.
Thread
Thread Starter
Forum
Replies
Last Post
Kidcutty
Small Blocks
24
June 4th, 2011 08:57 AM