Hi!

Can anybody provide me with a picture of the damping mat that's behind the rear bench in a '70 cutlass between backrest and the trunk divider sheet metal? Preferrably in place without rear seat.

Want to cut my own and want to be close to original.

Thanks

 

Are you looking for an original only or can a repop work? The latter I have...

 

I'll take anything for inspiration/orientation, thanks

 

Here it is, hope it helps.
It only hangs on those two hooks in the center. I used a couple screws at the sides for my own custom installation...
I also have the factory jute mat that hangs over this on the seat side, but it is not on there yet. It is about the same size.

 

I thought there's some more magic to it than a plain square...

Thanks for the image, I'll get creative then.

 

It's been awhile, but I'm pretty sure I pulled out the stock one from a '72. The sides were scalloped a bit so the bottom was narrower than the top, maybe by 6" or so on each side, starting about halfway down.
It was just thin cardboard.

 

Well I come to realize you want a picture of the mat, not the board...
Well the mat is the same rectangle as the board and hangs on the same two centerish hooks. It is about 3/8" thick.
You can see a little of my original in the following shots: