Anybody have any luck with these as far as performance wise.
I usually go bmr or qa1 but idk throwin feelers out.

 

Id call them and ask
(1) where are they made
(2)are they dimensionally any different than stock
(3)who makes the ball joints,
I here people complain about the oversea s arms having junk ball joints that should be replaced with Moog or equivalent

 

X2 70W-32. I bought ALL Hotchkis front and rear components for 64 F-85 "post car " build.

 

Those are the same offshore Chinesium control arms found everywhere. The Arms themselves are ok, but some people have had serious issues with the ball joints. Enough issues to warrant swapping the ball joints out with MOOG or some other quality part.

 

That's good to know. I've read folks say the imported parts were junk. Ball joint failure is a serious concern.

 

You can stay original by using used parts if you'd like. 2blu442 thinks he has them. Used arms may likely need new bushings. Replacing the bushings isn't complicated.