Hei

Reply Subscribe

Thread Tools

Search this Thread

August 13th, 2015 | 05:37 PM

71oldsS

Thread Starter

Registered User

Joined: Jun 2012

Posts: 54

From: St. Louis

Hei

Am I correct in thinking that I don't need the resistance wire coming from firewall that would go to the coil with my new HEI? Thanks again for any advice.

August 13th, 2015 | 05:56 PM

Oldsmaniac

Registered User

Joined: Oct 2005

Posts: 7,113

From: NJ

Correct but you do need 12v to the hei + terminal on the cap so you will need to run a wire or find one that is powered with ignition switch on.

August 13th, 2015 | 06:42 PM

71oldsS

Thread Starter

Registered User

Joined: Jun 2012

Posts: 54

From: St. Louis

Is that in addition to the 3 wires coming from distributor, 1 ground and 2 going on coil? new at this

August 13th, 2015 | 07:38 PM

oldcutlass

Administrator

Joined: Oct 2009

Posts: 41,125

From: Poteau, Ok

The 3 wire plug that runs from the cap into the body of the distributer is left alone, its there to remove the cap. You need a 2 prong plug like this the red wire is power and the green is for a tach.