72 cutlass correct rear end detail
#2
Axle tubes- 60% gloss(Semi gloss)
Backing plates - Bare steel or 60% black(Most were Black)
Center section - Bare cast iron
Diff. cover - Bare steel or black(Most were black)
Shocks - Grey
springs - Black Or bare steel(Most were Black)
Drums - Bare steel cast (Rally wheel car has face painted black, Hubcap car no paint)
sway Bar - Bare Steel or Black(Most were black)
If you really want to be assembly line correct after all this spray everything black with a spray bomb from the rear. Just make a mess of it The idea behind this was it needed to look good on the lot for aprox. 30 days . They didn't want to see rust.
Backing plates - Bare steel or 60% black(Most were Black)
Center section - Bare cast iron
Diff. cover - Bare steel or black(Most were black)
Shocks - Grey
springs - Black Or bare steel(Most were Black)
Drums - Bare steel cast (Rally wheel car has face painted black, Hubcap car no paint)
sway Bar - Bare Steel or Black(Most were black)
If you really want to be assembly line correct after all this spray everything black with a spray bomb from the rear. Just make a mess of it The idea behind this was it needed to look good on the lot for aprox. 30 days . They didn't want to see rust.
Last edited by 68442; June 3rd, 2017 at 04:03 PM.
Thread
Thread Starter
Forum
Replies
Last Post
oldspackrat
General Discussion
2
December 15th, 2015 07:43 PM
350TurBRO
Transmission and Driveline
6
September 12th, 2014 11:52 AM
2blu442
General Discussion
13
July 2nd, 2013 10:42 AM