As my build is coming to an end its all the little things left. I noticed that the shop pulled off the the old vinyl (i assume) from the car. I see that its now metal and painted the color of the car in that location. So I ordered the replacement vinyl for it but its not in any pre cut design its just a roll of vinyl that is large enough to fit after some basic cuts.

My question is what do I use to install this? Weatherstrip adhesive? Are there some special instructions? I added a pic from OPGI site so folks know what exactly I'm speaking about.

Thanks in advance

 

I'm doing the same thing and I was going to use 3M Super 77 Multipurpose Spray Adhesive for the job. A bit worried about bleed through so I was going to test before doing it.

 

You're in Mokena I'm right down the street in Matteson. Hope to see you around the area. Never thought about the spray adhesive thats probably a good method as well. I have about another week before she is home and I'll do it then. So if you do it before would like to know how it turned out.

 

Cool - we are pretty close! My dash is out and I'm painting it this weekend, and I've got my interior restoration kicked off, so it may be while before I'm mobile. PM me when you have got her back - I'm going from a saddle interior to a white one and I could probably pick up a few tips since your interior color scheme is where I'm headed.

Here's a few pix