Doug Carner

I just picked up my freshly machined 455 block (bored. 030 over) and need some advice on bearings. For those who have been there done that, please share your recommendations on main and rod bearings. I've been reading about narrowed bearings, coatings, v groove, extra oil clearance, etc. What are the best bearings for a mild build with 10.5:1 compression? I appreciate your input as this is my first BB Olds build. I need .010 under too.

cutlassefi

The best mains are Federal Mogul 108M-10. rods should be Clevite CB 542P-10. Cam bearings should be Durabond 06-B.
Hope this helps.

Thanks.

Doug Carner

Mark you are always quick to respond and I appreciate your wisdom and experience! I will get those ordered tomorrow. (-: