374 Olds 350 stroker build
#44
Out of Line, Everytime😉
Thread Starter
Join Date: Dec 2006
Location: Melville, Saskatchewan
Posts: 9,140
Talked to Parkland Engine Builder's, still wicked busy. Hopefully they will have the block ready by the end of next week. Then I can order the custom pistons, pins, rings along with rod and main bearings from Cutlassefi.
#45
Out of Line, Everytime😉
Thread Starter
Join Date: Dec 2006
Location: Melville, Saskatchewan
Posts: 9,140
I contacted the machine shop, still not done, they are hoping they can get it done in the next couple of weeks. I told them if the block won't clean up at 4.065", go to 4.070" or 4.080" due to available ring sets. Only has been 2 months.
#46
Out of Line, Everytime😉
Thread Starter
Join Date: Dec 2006
Location: Melville, Saskatchewan
Posts: 9,140
These parts arrived today. I am installing the fan controller this weekend. I am leaving the rad for the new motor. Speaking of that, still no word from the machine shop, hopefully soon so I can order pistons. FYI, I have $1000 just for the starter, rad and fan controller. The 330 stroked and ground undersized 330 crank, 1/2" Halo and studs, another grand.
Last edited by olds 307 and 403; March 31st, 2021 at 08:31 PM.
Thread
Thread Starter
Forum
Replies
Last Post
shoehorn_hands
Small Blocks
0
April 5th, 2020 05:06 PM