When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Talked to Parkland Engine Builder's, still wicked busy. Hopefully they will have the block ready by the end of next week. Then I can order the custom pistons, pins, rings along with rod and main bearings from Cutlassefi.
I contacted the machine shop, still not done, they are hoping they can get it done in the next couple of weeks. I told them if the block won't clean up at 4.065", go to 4.070" or 4.080" due to available ring sets. Only has been 2 months.
These parts arrived today. I am installing the fan controller this weekend. I am leaving the rad for the new motor. Speaking of that, still no word from the machine shop, hopefully soon so I can order pistons. FYI, I have $1000 just for the starter, rad and fan controller. The 330 stroked and ground undersized 330 crank, 1/2" Halo and studs, another grand.
Last edited by olds 307 and 403; Mar 31, 2021 at 08:31 PM.
