350 aluminum intake????
#1
350 aluminum intake????
I have taken the intake off the 350 today an found how truly heavy it is,I wanted to know if the aluminum intake off the 307 would work just just fine?or is there a intake that will still fit the stock carb ? an my plans are to get #5 heads or 7a heads done up for this engine an maybe a cam well most likely a cam an sorry for the noob question .
#3
I have taken the intake off the 350 today an found how truly heavy it is,I wanted to know if the aluminum intake off the 307 would work just just fine?or is there a intake that will still fit the stock carb ? an my plans are to get #5 heads or 7a heads done up for this engine an maybe a cam well most likely a cam an sorry for the noob question .
Its been RUMORED that the A4 and the Ebrock Performer have very similar performance properties, but I personally havn't done the research.
John
#4
If there is an A4 cast into it, on the passenger side of the intake by the water neck... that is the one you want. If its the A5, then its not desireable. Its more constrictive.
Its been RUMORED that the A4 and the Ebrock Performer have very similar performance properties, but I personally havn't done the research.
John
Its been RUMORED that the A4 and the Ebrock Performer have very similar performance properties, but I personally havn't done the research.
John
Thread
Thread Starter
Forum
Replies
Last Post
TIM FISKUS
Parts Wanted
5
May 12th, 2013 05:17 AM
scubastever
Small Blocks
1
August 27th, 2010 12:20 PM