Shifter Linkage
#1
Shifter Linkage
Hi All!
I have a column shift car that originally had a metal rod linkage that went to a jetaway. I swapped out for a TH350 and we are working on finishing touches. I noticed that there is a metal shaft that attaches to a bracket that is attached to the frame under the drivers side next to the shifter mechanism on the transmission.
There seems to be a ball type connector that slips into the bracket that is not on the linkage I have. Does anyone know where I can get that piece that slips into the bracket? Also, will this same shifter linkage work with the TH350 as it did with the Jetaway?
Here are a couple pictures...
Thanks!
Bryon
Bracket on frame (left side) across from shifter lever (on right).
Column shifter linkage
I have a column shift car that originally had a metal rod linkage that went to a jetaway. I swapped out for a TH350 and we are working on finishing touches. I noticed that there is a metal shaft that attaches to a bracket that is attached to the frame under the drivers side next to the shifter mechanism on the transmission.
There seems to be a ball type connector that slips into the bracket that is not on the linkage I have. Does anyone know where I can get that piece that slips into the bracket? Also, will this same shifter linkage work with the TH350 as it did with the Jetaway?
Here are a couple pictures...
Thanks!
Bryon
Bracket on frame (left side) across from shifter lever (on right).
Column shifter linkage
Last edited by 1968CutlassSupreme; September 23rd, 2017 at 08:02 PM. Reason: Added Pictures
#3
#4
Joe,
Could I not just replace the original linkage with something like what is shown here at this website?
http://www.honestcharley.com/hot-rod...0-400-700.html
Thanks!
Could I not just replace the original linkage with something like what is shown here at this website?
http://www.honestcharley.com/hot-rod...0-400-700.html
Thanks!
#6
Joe,
Could I not just replace the original linkage with something like what is shown here at this website?
http://www.honestcharley.com/hot-rod...0-400-700.html
Thanks!
Could I not just replace the original linkage with something like what is shown here at this website?
http://www.honestcharley.com/hot-rod...0-400-700.html
Thanks!
Seriously, you have all the parts now except for the little "U" bracket on the trans. Nothing will work better than the stock parts.
#7
Thanks.
Secondarily, and I sincerely hope this does not seem rude, but I can't help but notice you have ignored all of my questions about the power steering bracket. Is that deliberate? I thought you offered to find and send me the bracket I need for the cost of shipping. Maybe I misunderstood.
Bryon
#8
Thread
Thread Starter
Forum
Replies
Last Post