Need a Complete 350, working / rebuildable
#1
Need a Complete 350, working / rebuildable
My current project has a Buick 3.8 V6 and I want to get back to a V-8, but never a SBC!
Last edited by Chuck Cole; September 16th, 2018 at 02:24 PM.
#2
Need a Complete 350, working / rebuildable
I have an original 1970 W-31 shortblock, that has been bored 0.030" over and has forged replacement pistons. It was run in an NHRA Stock Eliminator car. The block has been built to factory blueprint specs and is balanced. It would need to be freshened up, with rings and bearings. I can provide a set of #6 heads and an aftermarket W-31 spec camshaft, a 7040250 carburetor re-done by Sparky to W-31 specs. I DO NOT have the aluminum intake or the factory balancer.
In addition to the above, I have numerous blocks, cranks, heads and intake manifolds (cast iron), along with an NOS set of aftermarket 0.030" forged pistons.
If interested in any parts mentioned, email me: drolds1@bellsouth.net. Shipping would be from South Florida. Thanks, Bob.
In addition to the above, I have numerous blocks, cranks, heads and intake manifolds (cast iron), along with an NOS set of aftermarket 0.030" forged pistons.
If interested in any parts mentioned, email me: drolds1@bellsouth.net. Shipping would be from South Florida. Thanks, Bob.
#4
I have a '69 350 with No. 5 heads, Eugene, Oregon.
From a '69 Cutlass S complete, running car, purchased to repair my '69 442.
Running strong before car was parted.
Contact: a_t_burk@hotmail.com
From a '69 Cutlass S complete, running car, purchased to repair my '69 442.
Running strong before car was parted.
Contact: a_t_burk@hotmail.com
Last edited by alburk; July 26th, 2018 at 05:12 PM. Reason: to change information
Thread
Thread Starter
Forum
Replies
Last Post
Ryan 1969 Chevelle SS396
Parts Wanted
6
February 14th, 2016 06:43 PM