Need a Complete 350, working / rebuildable

Reply Subscribe

Thread Tools

Search this Thread

July 26th, 2018, 11:59 AM

Chuck Cole

Oldscarnut

Thread Starter

Join Date: Jul 2018

Location: NW Washington

Posts: 421

Need a Complete 350, working / rebuildable

My current project has a Buick 3.8 V6 and I want to get back to a V-8, but never a SBC!

Last edited by Chuck Cole; September 16th, 2018 at 02:24 PM.

July 26th, 2018, 12:52 PM

ROCKETMAN269V

Registered User

Join Date: Apr 2007

Location: South Central Florida

Posts: 2,732

Need a Complete 350, working / rebuildable

I have an original 1970 W-31 shortblock, that has been bored 0.030" over and has forged replacement pistons. It was run in an NHRA Stock Eliminator car. The block has been built to factory blueprint specs and is balanced. It would need to be freshened up, with rings and bearings. I can provide a set of #6 heads and an aftermarket W-31 spec camshaft, a 7040250 carburetor re-done by Sparky to W-31 specs. I DO NOT have the aluminum intake or the factory balancer.
In addition to the above, I have numerous blocks, cranks, heads and intake manifolds (cast iron), along with an NOS set of aftermarket 0.030" forged pistons.
If interested in any parts mentioned, email me: drolds1@bellsouth.net. Shipping would be from South Florida. Thanks, Bob.

July 26th, 2018, 03:17 PM

rktolds

Registered User

Join Date: Apr 2009

Location: Olympia,WA

Posts: 1,731

I have a 73 350 that’s a runner. I have a complete 70 350 4 brl motor that turns partially. Has a spun bearing or something preventing full rotation. I’m in Okc area.

July 26th, 2018, 05:06 PM

alburk

Registered User

Join Date: Aug 2010

Posts: 88

I have a '69 350 with No. 5 heads, Eugene, Oregon.
From a '69 Cutlass S complete, running car, purchased to repair my '69 442.
Running strong before car was parted.
Contact: a_t_burk@hotmail.com

Last edited by alburk; July 26th, 2018 at 05:12 PM. Reason: to change information