My current project has a Buick 3.8 V6 and I want to get back to a V-8, but never a SBC!

 

I have an original 1970 W-31 shortblock, that has been bored 0.030" over and has forged replacement pistons. It was run in an NHRA Stock Eliminator car. The block has been built to factory blueprint specs and is balanced. It would need to be freshened up, with rings and bearings. I can provide a set of #6 heads and an aftermarket W-31 spec camshaft, a 7040250 carburetor re-done by Sparky to W-31 specs. I DO NOT have the aluminum intake or the factory balancer.
In addition to the above, I have numerous blocks, cranks, heads and intake manifolds (cast iron), along with an NOS set of aftermarket 0.030" forged pistons.
If interested in any parts mentioned, email me: drolds1@bellsouth.net. Shipping would be from South Florida. Thanks, Bob.

 

 

I have a '69 350 with No. 5 heads, Eugene, Oregon.
From a '69 Cutlass S complete, running car, purchased to repair my '69 442.
Running strong before car was parted.
Contact: a_t_burk@hotmail.com