I am in need of a section of rear chassis for my 68 Toronado. It is the frame rail that goes up and over the driver side rear wheel, and extends back to the rear bumper.

I am almost sure all 1st generation, '66-'70, are compatible.
If the car is local to SE Pennsylvania, I might be interested in the entire car, otherwise I would just want that section shipped to me.

 

I'll check if any of my '68s have anything usable...

 

There's a 68 Toronado in Louisville,Ky. at the Pull a Part. It's been there for a couple of months. Very nice original car that had burned from the inside of the car. The frame and everything else looked really clean. Don't know if you're in a position for a road trip or not. Just trying to help out.

 

KY is closer than I am .. I'm in Wisc.
I do have a few '68s I'd sell as whole parts cars... and 10 1st generation Toros I am tearing down I am sure would have at least the frame horn Ya are looking for Bob.. If all 1st gen.s are the same.
One of the 67s had a solid as a rock floor in it last time I was in it... (read; 8 years ago) , so I am thinking of checking that one first.