im looking for a set of 455 heads im rebuilding a 71 olds 98 and the heads where bad

 

Where are you located? I have a set of 71 G heads i could sell $75 for the pair. Thanks brandon reynolds

 

I have a set of rebuilt E heads asking 600 . They are ready to run, I was going to use them but got a deal on a set of edelbrock heads

 

I have a few sets. If Im close to you I can help.

Matt

 

X2 on your location. I have sets in Indiana

 

im in Manteca,CA anyone near?

 

I have a pair 71 G-heads.They are good original cores,from a running engine,never rebuilt or modified.I will ship anywhere.

 

I am in Oregon and have the following heads: B, C, K, G, J Prices vary you can contact me at lemoldsnut@aol.com or call at 541-279-4363 between 8 am and 8 pm our time. (West Coast)
Thanks
Larry

 

I live in Hayward, about 50 miles from you. Mine are all cores, I think I have C, E,G, Ga, and K.

 

Did you ever get a set of heads? I have a set of E's all done up ready to go.

 

What's done to those E's?

 

Sorry Brian I meant C's.
Complete valve job
All new seats
All new seals
Resurfaced heads
Magnafluxed heads
5 new guides
Had a.i.r. Bumps ground down
Harland sharp s50026a roller rockers
CutlassEFI provided all the springs and retainers

 

Having a new 468 built,these heads have less than 500 miles on them.

 

Ok. I was intersted if they were E's,but Dan Macal is looking for heads too. I'll let him know.

 

I think I have a set of E's but they need work....

 

Heads were cleaned, valves and seats were cut. new springs , bronze guides and retainers. This was a stock valve job no port matching decking or porting. Ready to bolt on and go.Heads3.JPG

 

Brian, what are you looking for in the way of Es? I have a couple of sets. E-mail me direct: drolds1@bellsouth.net. Thanks, Bob.

 

What is with the "E" heads? I have a set in Baltimore---Bs and Cs here in NC.