KA Pulley
#3
I am not sure if they are the same, would you happen to have the pulley width and depth measurements? I’ll have to do a little research to see, if they are the same what would you have to have for it?
#4
If it helps I think your looking for part number 401462 (I don't think the part number is stamped though). 2 groove, Around 6.8" OD, 2.4" deep (info from Chris Witt's pulley spreadsheet). I didn't think the KA was used in 70. Definitely 68-69 W30, W31
Last edited by allyolds68; October 28th, 2021 at 07:32 AM.
Thread
Thread Starter
Forum
Replies
Last Post