1972 Cutlass bolt in axle shafts
#1
1972 Cutlass bolt in axle shafts
Hi Guys...I’ve looked all over the internet searching for new axle shafts for my 1972 Cutlass
i have the 8.5 / 28 spline carrier with bolt in axles. All I can find are c clips axle shafts. Can any guide me
to where I can find new axle shafts that fit.
Thanks, Jim
i have the 8.5 / 28 spline carrier with bolt in axles. All I can find are c clips axle shafts. Can any guide me
to where I can find new axle shafts that fit.
Thanks, Jim
#2
Contact member monzaz.
https://classicoldsmobile.com/forums...rs/monzaz.html
https://classicoldsmobile.com/forums...rs/monzaz.html
#3
1972 Cutlass bolt in axle shafts
I have numerous used axles down here in sunny South Florida, if you're interested. Email me direct: drolds1@bellsouth.net. Thanks, Bob.
#10
There are no 31 spline shafts for the 1971-1972 corporate 10 bolt rears; those were only for the 1967-1968 heavy duty O-Type.
There are 30 spline axle shafts for the corporate 10 bolt rear, though.
There are 30 spline axle shafts for the corporate 10 bolt rear, though.
#11
These are for the 8.5" type "O" rear end, as mentioned above; however, they fit up to '69. This is the rear, sometimes mistakenly referred to as an Olds "12-bolt", because it has 12 bolts in the rear end cover, but only ten holding the ring gear on. They will not work with a '71 or newer rear end.
Thread
Thread Starter
Forum
Replies
Last Post
cletusvandamme
Drivetrain/Differentials
28
May 18th, 2014 07:51 PM