Ported Ka heads
#1
Ported Ka heads
Hi: I'm selling a set of Ka 455 Cylinder heads. They are set up for a Hydraulic Roller Cam(.562 lift). They are pocket ported, intakes ported right through, exhaust roof raised, floor left as is. Engine pulled 496 H.P@ 5375 RPM and 573 Lb\ft Torque@ 3843. The heads have mostly dyno time and a small amount of cruising. They work well, but my front end is too heavy and I mash my headers on invisible bumps on the road ??? I am also selling the push rods and Pro Form aluminum (1.6) adjustable rockers for same. I will also be selling a gasket matched Edelbrock Torker intake which was also on the engine at Dyno. Like I say heads worked fine, tons of tire burning torque, bit I just want to lighten the front end up!!
Interested ??? email at wvlaurie@mymts,net.
Interested ??? email at wvlaurie@mymts,net.
#3
$1250.00 Canadian Currency
Hi $1250.00 Canadian Currency for Intake, Heads, ProForm roller rockers and pushrods. I would ship out of Neche, North Dakota, purchaser would be responsible to ship to final destination.
#9
Hi: The heads have factory W-30 valves, with a 3 angle valve job done by a local machine shop, Millar Racing engines in Winkler , Manitoba. They went over the heads just before I put it together and got it Dyno'd. 21 pulls to 6000+ RPM without a hiccup. Millar set the valve heights and spring tension for my Lunati Voodoo Hyd, Roller cam as well.
Wayne
Wayne
#11
Ka Heads
Hi: Yes crossovers are filled with aluminum/tin/zinc alloy, right through, and blended into the exhaust pocket. These heads are still on the car and running, just started to take it apart, waiting for new parts to arrive.
Wayne
Wayne
#12
ka heads
Wayne
Thread
Thread Starter
Forum
Replies
Last Post
gearheads78
Parts For Sale
5
July 5th, 2010 10:25 AM