C heads
#1
C heads
Have a set of C heads big valve with about 300 miles on them.
All new valves
All new seals
All new seats
Complete valve job
Magnafluxed
Been resurfaced
5 new guides
Guide plates
Had A.I.R bumps ground down
CutlassEFI provided the springs and retainers
Date code are from 67-69
$750 obo
All new valves
All new seals
All new seats
Complete valve job
Magnafluxed
Been resurfaced
5 new guides
Guide plates
Had A.I.R bumps ground down
CutlassEFI provided the springs and retainers
Date code are from 67-69
$750 obo
Last edited by Stevec; February 16th, 2014 at 03:46 AM.
#6
As a novice to Olds heads, would these heads increase the compression ratio of a low compression 455 or is the compression ratio determined by the pistons? I have a stock '73 455 with 8.5 - 1 compression and so a little higher efficiency through higher compression would be nice.
Chris
Chris
#10
I had BTR build me a 468 I'm about a week or 2 away from firing it up.
These heads are from a 400 I refreshed awhile back,I really want to get rid of these c heads they are too nice to sit in my basement.
They are ready to run!
These heads are from a 400 I refreshed awhile back,I really want to get rid of these c heads they are too nice to sit in my basement.
They are ready to run!
#12
Steve,
Send me some pics, and info. Assume theses are the heads that the roller rockers came from? Might be able to use them, even though I had my B heads done. Tom@spa-poolspecialist.com
Send me some pics, and info. Assume theses are the heads that the roller rockers came from? Might be able to use them, even though I had my B heads done. Tom@spa-poolspecialist.com
#17
could you please send me pics and info. thanks rblatcher442@yahoo.com
Thread
Thread Starter
Forum
Replies
Last Post
64 CUTLASS KEN
Big Blocks
44
December 7th, 2020 06:43 AM