70-72 Center Console
#1
70-72 Center Console
SOLD...
I have a complete unrestored 70-72 center console. The top piece is in good condition, but not perfect. It has a 1" crack in it. The bottom (base) piece has several defects. I have repaired all of the issues with a hard plastic putty. You cannot see any of these when the unit is assembled (photos) except one. The trim has been removed, but is included and has been professionally polished. It is complete with top plate, lense and wiring harness. The top plate will need replaced. I was going to use this in my restoration, but I purchased a hurst dual gate already complete off e-bay. Obviously not perfect thus, the price...$175 plus shipping...
Chuck
I have a complete unrestored 70-72 center console. The top piece is in good condition, but not perfect. It has a 1" crack in it. The bottom (base) piece has several defects. I have repaired all of the issues with a hard plastic putty. You cannot see any of these when the unit is assembled (photos) except one. The trim has been removed, but is included and has been professionally polished. It is complete with top plate, lense and wiring harness. The top plate will need replaced. I was going to use this in my restoration, but I purchased a hurst dual gate already complete off e-bay. Obviously not perfect thus, the price...$175 plus shipping...
Chuck
Last edited by hinz57; April 5th, 2012 at 05:16 PM.
#5
Hi Chuck, could you send me some photos of the underside of the top piece, where the PRNDL light goes. I am trying to repair a console that has that piece cut out for a dual gate (I have a normal shifter), and am trying to get an idea of what that bit looked like. If you could put a small ruler next to the part that would be fantastic.
thanks, Peter
thanks, Peter
Thread
Thread Starter
Forum
Replies
Last Post
bear71
Interior/Upholstery
5
March 27th, 2007 08:59 PM