I know there was an extensive discussion with photos on the correct position and width of the stripe on a 68 . I am ready to paint fenders and can't find the thread. Any help would be appreciated.

 

think you mean the w-36 stripe.......

https://classicoldsmobile.com/forums...n-springs.html

 

Thanks

 

These are some pictures I took awhile back. Note that the numbers are also in a different position than cars without the stripe.

Randy C.

 

Can you tell me the dimensions . Hard to read the last picture.

 

From the bottom edge of the stainless trim to the top of the numbers, I measure 12 11/32" on both sides. From the back edge of the fender to the number edge, it measures 1 1/4" on both sides.

That's about as close as I can get. Hope this helps.

Randy C.

 

Thanks Randy. Before I paint them , I am going to post a picture of the stripes laid out. No need not to get them right. John

 

Page 3 of this this previously mentioned thread shows a dimensioned layout.
???

 

John - check out the first entry on page 3 of wmachine's mentioned thread. You won't get anything better than those dimensions.

Randy C.