Few thoughts and help
#1
Few thoughts and help
1st Powder coat or not powder coat.
. Thinking of powder coating my performer intake to match the engine, and the tops of my alunimun valve covers.
looking for thoughts
2nd. Serpentin belt set up not aftermarket but other gm set ups, found a gbody site that listed some junk yard parts to make it happen
. Thinking of powder coating my performer intake to match the engine, and the tops of my alunimun valve covers.
looking for thoughts
2nd. Serpentin belt set up not aftermarket but other gm set ups, found a gbody site that listed some junk yard parts to make it happen
#3
1st Powder coat or not powder coat.
. Thinking of powder coating my performer intake to match the engine, and the tops of my alunimun valve covers.
looking for thoughts
2nd. Serpentin belt set up not aftermarket but other gm set ups, found a gbody site that listed some junk yard parts to make it happen
. Thinking of powder coating my performer intake to match the engine, and the tops of my alunimun valve covers.
looking for thoughts
2nd. Serpentin belt set up not aftermarket but other gm set ups, found a gbody site that listed some junk yard parts to make it happen
Why do you want to screw around with a serpentine setup? Unless you use a true reverse rotation water pump (either from an Olds V6 diesel or adapted from a Chebby), the psuedo-serp setups require a boatload of idler pulleys to force the belt into contact with the driven pulleys. There's a lot of work and no benefit.
Thread
Thread Starter
Forum
Replies
Last Post