Good Morning,

Does anyone have photos or diagrams for assembly of the top interior of the windshield for a '70 Cutlass convertible? Trying to see and ensure we have all trim pieces on the top/inside of the windshield header(trim, gaskets, panels) to then test top fit and put on latches, sun visors, etc. There seems to be little to no photos and information on this area of the car to make sure you've got everything you need to properly finish and seal the top. Sides of A-pillar are easy, but this is throwing me for a loop. I have a photo attached of the area in question, just need help with the parts and how they go together to finish this area.

Thanks if anyone has anything.

-Ryan

 

The picture is small, but It kooks like all the trim pieces are there. The seal goes on the folding top header bow.

 

I should have clarified that isn’t my 442, just photo for example. Just unsure of what goes between the windshield trim and between the sections that close off the interior header. Is it sealant?

 

I just put my windshield trim in and did not use anything. Found out that it is easier to put the lower screws in first, then the upper screws, then tighten.