Looking for the thread that mentioned
#1
Looking for the thread that mentioned
someone removing the wheel tubs on a 68 cutlass in order to tighten down and align the hood / hinges. Tired of trying to align it by opening and closing it over and over and not getting it right......have to replace the heater core as well so thought I would try the hood this way. Anyone else tried it? All my nuts and bolts are new so no big deal to r & r them.
#2
#3
Nope, not the one...someone mentioned they had laid on the floor and reached up under the hood ( with the hood closed) to tighten the hinge bolts while a helper made sure the hood was closed with the correct spacing ( they had the well tubs out for whatever reason........)
Thread
Thread Starter
Forum
Replies
Last Post