Look what found
May 7th, 2018, 02:46 PM
#10
Registered User
Join Date: Aug 2013
Location: Evansville, IN
Posts: 10,280
How does one run them? Two four barrel Holleys I assume. Are they set to run in parallel, like the front carb copies the back carb, or do you go on the front two barrels then dump 6 in when you hammer it?
May 8th, 2018, 05:27 AM
#11
Registered User
Thread Starter
Join Date: Jun 2011
Location: KANSAS CITY, KS
Posts: 2,030
I ran a few back in the eighties and nineties on small block Chevys
I ran the smallest Holley 4-barrel I could, the the front carb was the primary and had it hooked on a progressive type linkage and the rear was a secondary wasn't bad didn't have enough gear though so you had the feather into it... But it was a blast I can't remember a car that I had as much fun as one of those things hanging out the hood....
This thing is freaking huge I'm really amazed at how big it actually is and heavy holy crap it takes two people to pick it up... I had to carry that thing through the swap meet and of course it was as far as away from the truck as it could be... suuuucked
This thing is freaking huge I'm really amazed at how big it actually is and heavy holy crap it takes two people to pick it up... I had to carry that thing through the swap meet and of course it was as far as away from the truck as it could be... suuuucked
Thread
Thread Starter
Forum
Replies
Last Post
11971four4two
Miscellaneous Classifieds
2
September 19th, 2016 12:20 PM
jensenracing77
General Discussion
4
December 12th, 2011 12:21 PM
