Is this worth trying to sell or toss it ??
#1
Is this worth trying to sell or toss it ??
I gutted this awhile ago from my 1970 Olds Cutlass/442 clone and I've held on to it for too long now.
I'm debating if it's even worth keeping to sell, or just to toss it.
I have zero intention of reusing it, and was only holding onto it to sell in case someone else might make use of it.
Thoughts ??
IMG_20141003_111458.jpg
I'm debating if it's even worth keeping to sell, or just to toss it.
I have zero intention of reusing it, and was only holding onto it to sell in case someone else might make use of it.
Thoughts ??
IMG_20141003_111458.jpg
#8
I can't tell in the picture but is the POA valve still there? If so then classic auto air will buy them as cores. Also like others have said. If the housing is not cracked then it is worth at least $50. If the threads are good on the lines and the rubber is not cracking then I sell them for $40 per line.
#9
Same thing here....the fiberglass housing. If it's not discolored/stained then it has some real value to someone. These are getting harder and harder to come by in real nice condition and the repro housings don't look remotely close.
Don't toss the stuff....at least offer it locally or take the time to advertise it on this site.
Happen to be SW of Chicago??
Don't toss the stuff....at least offer it locally or take the time to advertise it on this site.
Happen to be SW of Chicago??
#11
The NW Suburbs about 35-45 minutes from downtown along I-90.
I also work near Park Ridge. A closer suburb on the NW Side.
Hey Steve, long time to talk.
Shoot me an offer via PM if you're serious. Thanks.
I also work near Park Ridge. A closer suburb on the NW Side.
Shoot me an offer via PM if you're serious. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post