Hi, anyone has a better exemple of this page, can't see in the red rectangle...

Thanks a lot

 

I have pdf copies of the '71 & '72 assembly manuals; my '71 copy is blurred just like yours, but the '72 page is clear. Most of the part numbers seem to match between the two model years so I think you can safely get the part numbers you need for the '72 page - see below.

Rodney

 

From the Parts Book

 

Thanks a lot

 

Thanks Joe, one question though, for the power steering setup for a 455 (water pump pulley 405461 and 405462) I found that they are code KM and KN,
but both have the same diameter of 7¼" and 2" in height, so why 2 different codes ?

Thanks

 

My data shows a slight difference in diameter. '461 is shown as 7.08", '462 is 7.30"

 

Ho ! Thanks, so I believe dimension on a lot of website are just rounded.

Can you confirm diameter of crank pulley KC=7.5" and KJ=6.25" ?
Trying to validate if pulley ratio are ok on my friend's 71 442.

Thanks again for your precious comments.