Hello All. I have recently bought a new engine wiring harness for my '67 Cutlass. I THOUGHT I was smart enough to remember where all the plugs went. Apparently not. There is a tan in color wire, with a boot on the end, that plugs in somewhere near the junction box but I cant figure out where. I have checked my 1967 Assembly Manual and there is a pic of the junction box w/o this wire and one with it. The one with it shows it plugging directly below the junction box. Nothing seems to be there for it to plug into. Is this the wire for the brake warning light?

 

I think you may be right.
Not real familer with the 67,
but is there a spot for it on the
brake junction, prop valve?
If I remember, a small brass tit there somewhere.

 

Yes tan wire goes to switch on brake distribution block.

 

Hey, i have a 67 CS, and i need of a wiring harnes, can i ask you where you got it from and how hard was it time was to install ? thanks brian

 

Are you talking engine harness? Got mine from M&H. Piece of cake to install. Can be done while drunk and still not feel bad in the morning. Harness around $118.

http://www.wiringharness.com

 

hey thanks for the info, must have missed the engine part, i'm in need of a full dash harness, since those pesky mice lived in my car for a unknown number of years. any and all help is welcomed, thanks brian

 

They have those too, but that harness is pricey.
You may want to post in the "Parts Wanted" forum and see if anybody has a decent one for sale.