My starter guy is rebuilding a core for me. He offered a Super Torque coil that he could get for it. Said it made it really powerful. Also said it could torque the nose off with a low CCA supply from a small and/or low battery.

Anyone have experience with these?

 

The factory had a few ways of winding the field coils. It would be interesting to get a wiring diagram and see how the Super Torque compares.

 

The housing of high-torque starters is different from those of low-torque starters.

 

Should have mentioned, the starter is an 1108387, hi torque, to the right on Joe's pic, and bottom left on VC's pic.

 

1108387 and 1108389 share the same housing. However the 1108389 has the higher torque of the two.

 

Maybe that is to what he was referring.

He did say to use a big battery with lots of CCA. He said that low batt could cause it to snap its nose....which I am wondering about.

 

I think the super torque coils would be fine and I don't think the nose would break if using them. Will you be using a starter support brace? The super torque coils are a little less expensive than the 387 coils and the super are a lot easier to install.The 387 coils have two shunt coils with one side of each being grounded and the other side of each going to the field lead that goes to the solenoid. That is 4 extra wires to attach and route. Take note of the threaded hole on the side of the field case. If you are using this, the super coils may be under the hole and if the bolt you put in is any deeper than the thickness of the case it may ground out the fields.

 

Understood.

I'll be adding the "heat shield" bracket that uses that hole. Does the brain trust remember the specs on the bolts used for it?