I need the mounts that are located right below the back of the front fenders. Are these body or frame mounts? These are badly deteriorated and make squeaking noises much like an old mattress. Are these difficult to replace and where is a good source for them. The ones in the back should probably be replaced too. Thanks for any help. .

 

They are body mounts. Fusick sells them by the complete set. you have to remove the bolts and jack up the body a little to slide them out. I'd spray rust penetrant on the exposed threads of the front ones. They are loctited by the factory and are tight. Be careful as they can break off if the threads are rusted. You could drill a small access hole above in the body and squirt in penetrant. Some people have broken them off and had to cut larger holes to access the caged nuts inside the body cavities.

 

Just replace all the body mounts at once. I got my kit from Fusiks. Spray all the bolts a few days ahead of time with some pb blaster and pray the nuts don't start spinning.

edit........ it looks like I posted this way after Rund. I started to reply about 30min ago and got busy with customers

 

Thanks for the response guys. I'll check with Fusiks and order a set.

 

How many are there?

 

I think there are 8 with bolts and 2 with no bolts if I remember right.

 

10 with bolts. On each side, 2 at firewall, 1 under door, one behind rear wheel, one at rear corner of frame. Generally there are only cushions in front of the rear wheel and up on the cross member at the differential.

 

Thanks again everyone. I have a set coming.