Driver side Rear end sits uneven have replaced springs, shocks .. It's annoying to look at its about a 3/4in difference on rear driver side.. Any idea on what else to look at? Thanks

 

1975 Chassis Service Manual, Figure 3.69, states, "Tolerance: Side to side +1/2" to -3/4" (Max difference 3/4")."

Don't be so picky.

If it really drives you crazy, put a 1/2" to 3/4" shim under the low spring.

- Eric

 

It could be a front spring causing this also.

 

I was thinking that that 3/4" difference might actually be within spec.

I held my thumb and forefinger 3/4" apart and then tried to decided if I'd notice that size difference in ride height from 10 feet or 50 feet or whatever feet away. I think the answer would be that I wouldn't have noticed it unless it was pointed out to me, and then it would forever bug me.

 

I know this is an old thread but I thought I would post in case someone else was curious. I have a 1975 Delta Convertible. I changed the original shocks and springs and have the same 3/4" inch difference in the rear. It did raise the rear about an inch though.