While lifting my 70 Conv. body off the chassis, my intermediate steering shaft caught on the engine and pulled the shaft out of the swivel joint, tearing the rubber boot. I found a replacement boot, but like to ask how to install it. Do I take the lower shaft out of the upper shaft? There appears to be a roll or shear pin between them, should I push or drill it out? or can the seal be stretched over the swivel end? Thanks, Bob

 

Never mind, as usual I found my answer with a search after posting the question. Apparently the swivel pin at the top must be pressed out to change the seal. I have a press so its no problem. Thanks anyway, Bob