Tried some POR-15
#1
Tried some POR-15
Was looking at coating my frame in POR-15 and figured I should try a sample piece before I dive in to make sure I like the results. Bought a sample kit and pulled my front bumper mounts. Gave it a shot this weekend and am amazed! Went on smoothly, although some dripped on my painted concrete floor and in trying to remove the stuff, if took the paint with it. I smacked the mounts with a hammer today to see it this stuff really holds up like they claim. It straight up dented my mounts and did not chip the coating at all!! This stuff is the shiz nit!
#2
Hopefully you did not mind a bent bumper mount...
I used the semigloss black POR15 on my convertible rear qtr access plates.
The next day I chunked a 3/8" ratchet extension at the back side to see how it would hold up - not a scratch!
I used the semigloss black POR15 on my convertible rear qtr access plates.
The next day I chunked a 3/8" ratchet extension at the back side to see how it would hold up - not a scratch!
#4
#5
Thread
Thread Starter
Forum
Replies
Last Post
jensenracing77
General Discussion
18
September 29th, 2013 07:26 AM
olds307owner
Eighty-Eight
5
May 17th, 2007 07:48 PM