Wanted: Hydra-Matic Transmission Tool Set
#1
Wanted: Hydra-Matic Transmission Seal Puller/Installer
In need of a rear seal puller/installer for a 1955 Oldsmobile Hydra-Matic transmission. Kent-Moore Part Numbers: J5930, J5948, J5946
Thank you very much!
Thank you very much!
Last edited by Larry Q; August 1st, 2010 at 10:47 AM. Reason: Revised Item
#2
1955 Oldsmobiles used a dual range hydramatic, turbo hydramatics came out in 64. If you are looking for tools for the older hydramatic, check EBAY. They recently had a really nice set of tools from snap on. Went for a couple of hundred. You can get the seal out of the older hydramatic with a typical seal puller, and to install it get a galvanized pipe coupling and cap that is the same size as the seal. Screw the cap to the coupling and use that as a driving tool.
Thread
Thread Starter
Forum
Replies
Last Post