Putting a cam back in
#1
Putting a cam back in
Sorry if this is a dumb question but i've gotten a lot of confusing info on this: Can a cam be taken out (to hone/bore the block) then put back in if all the lifters are put back where they came from? If so, does it matter if they're rotated in place or not? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
steve19
General Discussion
3
December 29th, 2008 05:21 AM
1BAD68"S"
Chassis/Body/Frame
4
November 30th, 2006 07:21 PM