Benton Illinios. Ran across these and had to share. Is the 88 very popular?
#1
Benton Illinios. Ran across these and had to share. Is the 88 very popular?
Any input on the 1963 dynamic 88? I was tempted to buy it.
The guy wanted 3900.00 for this one
This one was complete 63 88 with some documentation for 1500.00 OBO. I wish I had room for it but don't. It's a v-8 bench seat car. Posted because I hate to see it sit there looking so restorable.
The guy wanted 3900.00 for this one
This one was complete 63 88 with some documentation for 1500.00 OBO. I wish I had room for it but don't. It's a v-8 bench seat car. Posted because I hate to see it sit there looking so restorable.
#2
Wow! I have the exact same 63! I got mine here in MD for $500. Literally, the only non-factory parts on it were the radiator hoses and some of the steering gear that had been replaced. I got it roadworthy, and drove it for 3 years in about the same condition as that one. I wanted to flip it for a profit, and while everyone thought it was cool, no one wanted it for any price. Mine is now rotting behind my garage as an engine/rear donor for a Gasser project when I hit the lottery.
Keep in mind that parts are almost impossible to find for restoration, and often they're overpriced (i.e.- desert sheet metal). I didn't restore mine because I would have been $40k deep in a car that might bring 10 on the market. On the plus side, high compression 394s and early Olds rears are AWESOME!
Keep in mind that parts are almost impossible to find for restoration, and often they're overpriced (i.e.- desert sheet metal). I didn't restore mine because I would have been $40k deep in a car that might bring 10 on the market. On the plus side, high compression 394s and early Olds rears are AWESOME!
#5
i think i used to own the cutlass...when i had it, it was a complete car...looks like someone pulled all the vert special stuff off..a shame...i sold it in about 03 when i lived in STL,,,needed motor work, and i sold it for more than 3900...looks just about the same as when i had it..i bought it out of a machine shed where it was sitting since the 80s..it had wire hub caps when i sold it..
#11
Thread
Thread Starter
Forum
Replies
Last Post