Vinyl roof delete
#1
Vinyl roof delete
Wanting to delete vinyl roof on a car. Are the chrome pcs. Between the vinyl top and the paint held on by studs that could be ground down or is there some sort of bracket holding them on that when removed would leave a hole to be patched in the sheet metal ?? Thanks for any info provided or pics showing the bracket
#2
some studs a couple holes...
ya just grab the stud with vice grips and twist and they snap..then a little metal work...the holse you need to weld close
well..i cant remember on a cutlass how many holes..but ive done it to chevelles, and IIRC theres 4..i dont remember how may holes on a cutlass, but think 2
ya just grab the stud with vice grips and twist and they snap..then a little metal work...the holse you need to weld close
well..i cant remember on a cutlass how many holes..but ive done it to chevelles, and IIRC theres 4..i dont remember how may holes on a cutlass, but think 2
#5
The die cast ends on each side have studs with nuts that you access from the inside - through the trunk on the rear piece and after you remove the inner rear quarter trim on the front piece. There is also a screw that is hidden under the stainless trim. The center stainless part snaps over plastic clips that are on weld studs on the quarter panel. The stainless trim just snaps into place.
Thread
Thread Starter
Forum
Replies
Last Post
80_Olds_Guy
General Discussion
0
August 1st, 2013 08:00 AM