When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I am replacing the chrome piping trim on the bucket seats. There was chrome bullet style end caps that were available to install so I bought them. The seats right now do not have the end caps. Thought they may have all been just taken off but as I try to fit an end cap I wonder if they are not supposed to have them cause they don’t fit well. They have molded in black bullets at the end of the back panel where the chrome trim stops. Question? Are they supposed to have the chrome ends caps and if so any tips on how they install?
Awesome, thanks. That’s what I figured. I wish I would have asked before I bought 12 of them, or better yet, i wish the parts would not be listed for “all” 68-72 cars in the catalog.
Originally Posted by 70Post
The factory did not use the "endcaps" on this year so don't use them. Problem solved.
X2, never had them. Unfortunately...you are going to find a ton of parts that EVERY 68-72 car had that are wrong or don't fit, or that were never used on your car! Caveat emptor......
Buyer beware indeed. I like to put a car back the way it came unless that is impossible or cost prohibitive. My 69, is pretty damn close to factory including numbers. My 70 I am restoring will not be as much due to the latter restriction because of some missing w30 parts. Thanks guys.
[qaQUOTE=mrolds69;1111189]X2, never had them. Unfortunately...you are going to find a ton of parts that EVERY 68-72 car had that are wrong or don't fit, or that were never used on your car! Caveat emptor......[/QUOTE]
1968 was the last year for the end caps. I needed a couple for mine that were missing. I ordered some & in typical aftermarket fashion the new ones aren't quite the same as the originals, they're a little smaller in diameter & didn't fit that well
1968 was the last year for the end caps. I needed a couple for mine that were missing. I ordered some & in typical aftermarket fashion the new ones aren't quite the same as the originals, they're a little smaller in diameter & didn't fit that well
I was wondering when installing the chrome end cap on the bucket seat trim if the end cap itself sits completely over the trim or just over the cut ends. They don't sit completely flush; as you stated above that the diameter is smaller. Did you come up with a solution for this problem or does someone sell better reproduction end caps yet? Thanks again