What have you done to your Oldsmobile today
#1642
Suspension Work and Paint
Installed new bushings, springs, shocks and ball joints.
I think my buddy John was thirsty after sand blasting.
Moog parts
Upper control arm mounting hole is looking a little egg-like
Thanks John for the free replacement!
Painted and ready for installation
Faux W27 rear end paint. Asked for a W27 cover for Christmas so I hope it's under the tree tomorrow morning.
I think my buddy John was thirsty after sand blasting.
Moog parts
Upper control arm mounting hole is looking a little egg-like
Thanks John for the free replacement!
Painted and ready for installation
Faux W27 rear end paint. Asked for a W27 cover for Christmas so I hope it's under the tree tomorrow morning.
#1644
Control arms
Looks nice Charlie, I've been busy modifing the upper control arms off of the donor car. I'm moving the ball joint hole back 11/16" and hope to get 4 degrees of positive caster.
Dennis
Dennis
#1648
Added 6 inches to the length of the frame/wheelbase in the donor car (95 Caprice) to put under my 1950 Olds 98. Easier than I thought it would be. I didn't have to cut and splice any fuel or brake lines and they all went back into the original clamps so they'll be out of the way.
#1649
All new LL 1157 bulbs in back of wagon after a few headlights replaced and found a wire I had connected that made the blinkers crazy and cut that. It was trailer harness. Now it works perfect. Oh and then scored a new in box Olds cam for $75 and a almost complete 67-68 TO code 31 spline 3.91 rearend on the cheap cheap cheap
#1657
Looks great!
Not much happening here in the frozen Iowa plains, where the high temps have been like 5 degrees, not factoring for wind chill..
Prior, put a new alternator on. Going to look at relocating the engine ground straps, as either the old regulator in the alternator was going bad,or have some bad grounds as the lights flicker when I use the headlights at night.
Going to install a fuel check valve off of fuel tank that I acquired, see if that helps solve the fuel drain back from carb...
Been considering getting some LED 1157 bulbs for the tail lights, on a previous thread several options given, pros/cons, a good video comparing Plasma LED, LED tower, to incandescent.
Off and on working on car's history with family for a binder along with dealer promotional items for car shows..
About all I got
Not much happening here in the frozen Iowa plains, where the high temps have been like 5 degrees, not factoring for wind chill..
Prior, put a new alternator on. Going to look at relocating the engine ground straps, as either the old regulator in the alternator was going bad,or have some bad grounds as the lights flicker when I use the headlights at night.
Going to install a fuel check valve off of fuel tank that I acquired, see if that helps solve the fuel drain back from carb...
Been considering getting some LED 1157 bulbs for the tail lights, on a previous thread several options given, pros/cons, a good video comparing Plasma LED, LED tower, to incandescent.
Off and on working on car's history with family for a binder along with dealer promotional items for car shows..
About all I got
#1658
Took the Old Lady (Mistress) to the coffee and cars show this morning. The ricers and BMW's were there in mass but the Oldsmobile still stood out despite her age. Good time was had by all..... Tedd
#1661
Put in all new firewall and underdash insulation while the whole interior was apart and the dash was out being replated and detailed. Still got a long way to go on the total restoration started a few years ago on the 66 Cutlass I've had since 1975.
#1662
After Break in run of the new 350. Installed R&M billet wire looms ( painted 350 gold) installed custom length plug wires and finalized HEI wiring. Finished off the day bending up 1/4" tube for TH350 modulator vacuum and secured to manifold.
#1667
#1668
Put my rear end on the floor
Removed the rear suspension and exhaust system. Tank looks new but painted, it's coming out next for the sniper EFI tank after I strip and paint the undercarriage.
#1669
Drove wagon last Friday to the little mountains in SE Oklahoma to go meet friends and camp out. No issues at all driving about 600 miles other than bad MPG (12). That carb has always ran and drove well but it never had gotten good mileage. Time to get back in it. I used it on my sons 350 truck and it did the same 12. On his truck I swapped my "race" 800 Qjet on and it got 14-15 ..LOL
Last edited by GEARMAN69; January 24th, 2018 at 12:57 PM.
#1678
Finishing up “custom” radiator hoses. I didn’t ike the way the lower hose fit and rubbed against the idler arm bracket on the frame. Trying to get all the lose ends done before the first engine fire up on March 17th.
#1679
Road Trip
The roads were mostly dry so I took a 400 mile round trip in the D88 Coupe to Detroit for the Detroit Auto-Rama and rolled the odometer over on the way home. Then had to give it a wash today due to a little bit of road spray. Back into winter storage for about another month or do.
#1680
Finished my steering wheel restoration. 😁
https://classicoldsmobile.com/forums/interior-upholstery/123415-1961-steering-wheel-redo.html
https://classicoldsmobile.com/forums/interior-upholstery/123415-1961-steering-wheel-redo.html
Last edited by 61Bat; March 5th, 2018 at 02:51 PM.