Frame for 1970 Cutlass 442
#4
These are the areas I think need repair/replaced.
Pits on the frame box where the forward body mount goes. The mount appears to have been repaired with an insert (maybe at the factory?).
The inner and lower drivers side rail.
Above the rear coil spring mounts pitting.
Pits on the frame box where the forward body mount goes. The mount appears to have been repaired with an insert (maybe at the factory?).
The inner and lower drivers side rail.
Above the rear coil spring mounts pitting.
#5
#6
Frame for 1970 Cutlass 442
I have a very clean hardtop frame that a body shop had stripped and then painted, only to find that the right front corner had been hit. It's fine behind the front crossmember. It will transport in the back of a long bed pick-up, if you want to drive over to the Ft. Lauderdale area to pick it up. Email me for pics, etc.: drolds1@bellsouth.net. Thanks, Bob.
#7
#8
#9
Frame for 1970 Cutlass 442
Ben, well we were finally able to connect on the sale of the frame. It was a pleasure to meet and talk with you yesterday. Good Luck! with your project and I'm glad that you were happy with the frame. Thanks, Bob.
Thread
Thread Starter
Forum
Replies
Last Post
1968 cutlass
Chassis/Body/Frame
1
September 25th, 2017 01:47 PM
sixty9olds
General Discussion
1
June 14th, 2011 06:43 PM
1969goatman
Parts For Sale
0
August 30th, 2010 07:44 PM