71 delta88guy

Hello everyone. Looking to get a pair of heads done,looking for 320 cfm @.700 lift or better. Cnc, or done personally. What has been your experiences? Cost? parts needed. My heads are bare.

67 Cutlass Freak

You could easily spend $2000 for maximum effort port job, and another $500-$1000 for parts depending on what you want.
What kind of heads did you buy, ProComp, or Edelbrock?


Here's a list of the best Oldsmobile builders in the industry, that I know of:


http://www.btrperformance.com/ This is Bill Trovato
https://www.facebook.com/pages/Berna...08309059257851 This is Bernard Mondello
http://www.mjproformance.com/ This is Smitty (Mark Smith)
http://www.jsmachineoldsmobile.com/home.html This is Jim Lapikas
https://www.facebook.com/pages/KTRE-...91814724168123 This is Knowlton's Thunderheads out of Minesota.
CJ Smith - Head Machinist @ Joe Mondello Racing Engines
931-459-2760 M-F 8am-5pm
CJSmith@Mondello.com This is Cody in Tennesee.
http://www.rocketracingperformance.com/ This is John Stolpa
http://www.dickmillerracing.com/ This is Dick Miller http://wiseperformanceengineering.vpweb.com/ This is Brad Wise http://www.mondellotwister.com/ http://oldsperformanceproducts.com/ This is Andy Miller

therobski

X2 67 Cutlass Freak-all these guys are good and VERY helpful here on this site.

firefrost gold

I would from looking at his work on here look at sending them to cutlass freak . I don't now if he is looking for work or not . I think if your going to have heads ported your better off getting them from the porting shop they can spread that price out and make little on sale and on the work . No shipping to just from.

71 delta88guy

Bought bare procomps.

67 Cutlass Freak

I could port them for you, but I'm a little backed up right now. I have 5 sets of heads lined up to port. I have a full time job, which is not porting cylinder heads, so right now you'd be looking at fall completion from me.
Check out this older thread that shows some of Smitty's porting skills -

https://classicoldsmobile.com/forums...mp-teaser.html