Saw stainless steel headers on e-bay with gasket for under 200.00. Anyone have experience with them?? I’m putting a 69 Toro motor into a 69 Cutlass to make a driver. Thoughts???

 

Be careful as those appear to show the same header for big blocks and small blocks. The big blocks (400, 425, 455) use a different header than the small blocks (260, 307, 330, 350, 403).

 

They are a very well made header. I squeezed them on my Olds 350. It sounds like they fit the BBO better, mine hit the mounts but the BBO mounts would clear due to the deck height and different mounts. A mini starter is probably necessary.

 

I have these on my 455 in my B-Body and they cleared a full-sized starter without issue.

 

I’ll assume your B body is a BigBlock? Correct??

 

Yes

 

I read your post again. Slower this this time. I see you stated it’s a 455. Thank You. 🤦‍♂️