72 parts needed *convertible*
Thread Starter
Registered User
Joined: Nov 2007
Posts: 13
72 parts needed *convertible*
Hello I am looking for a few parts for my newly acquired 72 Cutlass convertible. Listed below are the parts in order
Trunk lid
Disk brake conversion (front) with master cylinder and booster
Power seat track (drivers side) car has original power seat but it only works up and down. *Would consider manual track
Bumpers front and rear *would like 442 rear bumper *have exchanges if needed front has rust dots rear (non 442) is peeling
Ram air hood
Front door panels with arm rests (white)
Dual exhaust (SMALL BLOCK WITH MANIFOLDS)
Center console (have one but has a crack towards the back)
350 alternator bracket (complete)
Any help on acquiring these parts would be greatly appreciated.
Thanks
GaryC
Trunk lid
Disk brake conversion (front) with master cylinder and booster
Power seat track (drivers side) car has original power seat but it only works up and down. *Would consider manual track
Bumpers front and rear *would like 442 rear bumper *have exchanges if needed front has rust dots rear (non 442) is peeling
Ram air hood
Front door panels with arm rests (white)
Dual exhaust (SMALL BLOCK WITH MANIFOLDS)
Center console (have one but has a crack towards the back)
350 alternator bracket (complete)
Any help on acquiring these parts would be greatly appreciated.
Thanks
GaryC
Last edited by 72DropTopCutlass; Nov 19, 2007 at 08:28 PM. Reason: add on
parts
Thread
Thread Starter
Forum
Replies
Last Post
