Heads #4,5,6
#1
Heads #4,5,6
Looking for a set of fresh 4,5,6 heads. I’m really looking for a set complete and ready to go. Not any good shops here in AZ so wanting a set from an olds man.
looking for a bolt on for a 1979 R code block with bolt holes opened up to 1/2.
Someone has to have a set they would part with.
thanks, mike
looking for a bolt on for a 1979 R code block with bolt holes opened up to 1/2.
Someone has to have a set they would part with.
thanks, mike
#3
Hi Dan,
I am very interested. I am actually looking for a set of heads for more than stock rebuild. The engine is a 79 R code 350 but with forged flattops, Molnar rods, 330 crank. Cam is a comp cams roller 236/242 @.050 lift 515/.530. I have the springs, locks, retainers, Harland rockers and screw in studs. I only have 2.07/1.72 Ferrera valves so those might not work. I’m seeking a set of heads for this mild little 350 that can breath. Thanks!
I am very interested. I am actually looking for a set of heads for more than stock rebuild. The engine is a 79 R code 350 but with forged flattops, Molnar rods, 330 crank. Cam is a comp cams roller 236/242 @.050 lift 515/.530. I have the springs, locks, retainers, Harland rockers and screw in studs. I only have 2.07/1.72 Ferrera valves so those might not work. I’m seeking a set of heads for this mild little 350 that can breath. Thanks!
#5
Hi Dan,
I am very interested. I am actually looking for a set of heads for more than stock rebuild. The engine is a 79 R code 350 but with forged flattops, Molnar rods, 330 crank. Cam is a comp cams roller 236/242 @.050 lift 515/.530. I have the springs, locks, retainers, Harland rockers and screw in studs. I only have 2.07/1.72 Ferrera valves so those might not work. I’m seeking a set of heads for this mild little 350 that can breath. Thanks!
I am very interested. I am actually looking for a set of heads for more than stock rebuild. The engine is a 79 R code 350 but with forged flattops, Molnar rods, 330 crank. Cam is a comp cams roller 236/242 @.050 lift 515/.530. I have the springs, locks, retainers, Harland rockers and screw in studs. I only have 2.07/1.72 Ferrera valves so those might not work. I’m seeking a set of heads for this mild little 350 that can breath. Thanks!
#6
Alabama
Hi Dan,
Thanks for the reply.
I think I’m going to need a little more information like your friends contact info so I can speak with him and discuss the project before sending any money.
Thanks for the reply.
I think I’m going to need a little more information like your friends contact info so I can speak with him and discuss the project before sending any money.
#7
Well you drug your feet so I don’t have time to go to storage and get them. You could have bought them and taken them somewhere of your choice ( which you can still do) but I don’t have time for you to call him and I have to meet him at a later date. He’s very well known in the oldsmobile community.
good luck 👍🏻
good luck 👍🏻
#8
Not a problem. I was traveling for the two (2) days. I'm sorry that was too long. I was just hoping to see what I would be buying before spending money. This is the internet.
Thread
Thread Starter
Forum
Replies
Last Post