Anybody have a 3 speed with shifter to fit Olds bellhousing? Must be close to Red Oak, TX. Will trade other parts.

 

I have the 3 speed shifter with rods, lmk via PM if interested.

 

I've got a couple 3 speed transmissions in Oregon if you don't find something closer.

 

Are you looking for the Saginaw (standard GM bolt pattern) or the Dearborn (Ford pattern)? Your bellhousing may have both bolt patterns.

 

Have an "ITM' three speed shifter, with rods, and plate, to mount to the tail shaft of a Saginaw transmission. Pulled a three speed IRON saginaw out of an oddball '71 Impala years ago, it had 49K miles, may? still have that, also.
Dave S southern new mexico 88012

 

Standard GM bolt pattern. The bell is from an X body with cable pull clutch release. I'm not sure but I don't think it has the Ford pattern.

 

I have a complete 3 speed set up in a 66 in Oregon that has been road tested.

lemoldsnut@aol.com
Larry
541-815-4363

 

Must be close to Red Oak, TX.

Thanks for the replys from far away, but I think I can find one closer. Even a Chevy pickup transmission will work for me.

 

Must be close to Red Oak, TX.
TTT

 

Ed, did you ever find a three speed? This Saginaw just popped up on FB marketplace. Of course, it's in PA.


https://www.facebook.com/marketplace...Anull%7D%22%7D

 

I have a 3 speed saginaw, came in my '65 Cutlass from the factory. Are you close to Ft. Wayne to pick up at the Pate Swap meet next month?

 

I'm close enough and normally would go to the Pate, but this year I have to pass.