67 Cutlass Sheetmetal
#1
67 Cutlass Sheetmetal
Looking for Sail Panel sheetmetal. See the picture. Hope you can help. Thanks Bob Copy of 20170829_161627.jpg
#4
Bob,
I may have what you need. Can you give appx. measurements on how high up the sail panel, and how far in to the deck area you will need?
I will give it a close look.
BTW, I am about an Hour away from you in Fishkill, NY.
Thanks
Darren
I may have what you need. Can you give appx. measurements on how high up the sail panel, and how far in to the deck area you will need?
I will give it a close look.
BTW, I am about an Hour away from you in Fishkill, NY.
Thanks
Darren
#5
Hi Darren, I just checked my post, surprised and happy to see a response, The measurements are 7" up where the glass sits, 7" back towards the trunk, 5" up the sail panel and 3" across the trunk panel. If you can help me out I don't mind a road trip. Thanks Bob
#6
Bob,
I just got the window out a couple days ago. And while mine is not nearly as bad as yours,
there still is a small hole there. You would still have to do some rust repair.
There was no real evidence of rust until I got the glass out and started poking at it.
Darren
I just got the window out a couple days ago. And while mine is not nearly as bad as yours,
there still is a small hole there. You would still have to do some rust repair.
There was no real evidence of rust until I got the glass out and started poking at it.
Darren
#7
Darren, Would it be possible for you to send me a picture. If you ever saw the amount of rust I have been dealing with on this car, a small hole is nothing. Also, would you have a cigarette lighter and wiper **** for a 67. Thanks Bob
Thread
Thread Starter
Forum
Replies
Last Post
springbryan
Parts Wanted
3
December 31st, 2012 05:08 PM